The calibration of current broadband seismometers with the aim to provide traceability to the International System of Units (SI) is an active topic in the vibration metrology community. As it turns out, this exercise has its specific challenges for the very low frequencies.
A major problem faced at that end of the applicable frequency range, is the influence of tilt as a disturbance on the measured motion component of the sensor.
In the presented work, the roles of the quantities are swapped. Tilt is used as a means of excitation of a seismometer and the rectilinear motion is considered as a disturbance, which is, however, well defined by the facilitated set-up.
As it is demonstrated, this approach can be very beneficial for the very low frequency calibration, and if applied correctly, it can provide a reliable link to base units of the SI.
Kostenfreier Zugang
Open Access Hybrid
Rechteinformation
CC BY 4.0 ; Creative Commons Attribution 4.0 License
Themenbereich der Metrologie
Akustik, Ultraschall, Beschleunigung
Geschäftsfelder
Metrologie für die Gesellschaft
; Metrologie für die Wirtschaft
Zitierung
Bruns, T., Klaus, L., Yan, N., & Gonzalez Duran, M. A. (2024). Ultra-low frequency calibration of broadband seismometers using a tilt table. Metrologia, 61(5). https://doi.org/10.1088/1681-7575/ad795a
