XXII IMEKO World Congress: Knowledge through Measurement, Belfast, 03-06, September, 2018, UK
Freie Schlagworte
ISO 7500-1 ; build up system ; Meganewton
Zusammenfassung
New developments in the field of structural engineering and regenerative power engineering require new testing facilities with forces in the two-digit meganewton range. For this purpose, a 30 MN testing machine for tensile and compressive testing was built at MPA Braunschweig and TU Braunschweig. The nominal load of this machine is thus greater than the largest European primary standard for tensile and compressive forces. To enable traceability to this standard up to 30 MN, a parallel connection of force transducers, a so-called build-up system (BU system), was used. For this purpose, the results of a EURAMET-funded research project (EMRB SIB 3) were used and further developed in order to enable a connection according to Standard ISO 7500-1. The procedure and the results are described in the following.
Kostenfreier Zugang
Open Access Gold
Rechteinformation
CC BY 3.0 ; Creative Commons Attribution 3.0 License
Themenbereich der Metrologie
Masse und abgeleitete Größen
Zitierung
Tegtmeier, F. & Gutsch, A. W. (2018). Calibration of a 30 MN material testing machine according to ISO 7500-1 using a force-transducer build-up system. Journal of Physics: Conference Series, 1065, 1–4. https://doi.org/10.1088/1742-6596/1065/4/042018
