| Zugriffsnummer | 34147 |
| Dokumenttyp | Zeitschriftenartikel |
| Peer Review | unbekannt |
| Sprache | Englisch |
| Titel | Supplementary comparison EURAMET.L-S24 on involute gear standards |
| Autor(in); Institution |
Kniel, Karin; 5.3, Koordinatenmesstechnik, PTB-Braunschweig
Chanthawong, N.; National Institute of Metrology of Thailand (NIMT), Pathumthani, THAILAND
Eastman, N.; Oak Ridge Metrology Centre, Oak Ridge, USA
Frazer, R.; National Gear Metrology Laboratory (NGML), Newcastle University, Newcastle upon Tyne, UK
Kupko, V.; National Scientific Center (NSC), Kharkiv, UKRAINE
Osawa, S.; National Metrology Institute of Japan (NMIJ), Tsukuba, Ibaraki, JAPAN
Xue, Z.; National Institute of Metrology (NIM), Beijing, CHINA
|
| Quelle/Jahr | Metrologia: 51 (2015), 1A, Tech. Suppl., 134 S. |
| Artikelnummer | 04001 |
| Availability | [online only] |
| ISSN | 0026-1394 |
| DOI | |
| URL | |
| Verlag | Bristol: IOP |
| Freie Schlagworte | comparison ; EURAMET TC-Length ; involute gear standards ; gear standards ; profile measurement ; helix measurement ; pitch measurement |
| Zusammenfassung | At its meeting in 2007, the EURAMET TC-Length decided to run an intercomparison of involute gear standards as a regional comparison with non-European involvement. The Physikalisch-Technische Bundesanstalt, Braunschweig und Berlin, Germany (PTB) was identified as the pilot laboratory, responsible for planning, organizing and analyzing the comparison. In all, seven participants from China, Germany, Japan, Thailand, Ukraine, United Kingdom and USA were asked to measure three different gear standards specialized for profile, helix and pitch measurements. The measurements started mid 2008 and were finished at the end of 2010. |
