| Zugriffsnummer | 27008 |
| Dokumenttyp | Konferenzartikel in Zeitschrift |
| Peer Review | unbekannt |
| Sprache | Englisch |
| Titel | Round-robin test of heat flux sensors |
| Autor(in); Institution |
Turzo-Andras, E.; Metrology Division, Hungarian Trade Licensing Office, HUNGARY
Blokland, H.; TNO Science & Industry, THE NETHERLANDS
Hammerschmidt, Ulf; 1, Mechanik und Akustik, PTB-Braunschweig
Rudtsch, Steffen; 7.4, Temperatur, PTB-Berlin
Stacey, C.; National Physical Laboratory (NPL), Teddington, UK
Krös, C.; South African Bureau of Standards, SOUTH AFRICA
Magyarlaki, T.; Metrology Division, Hungarian Trade Licensing Office, HUNGARY
Nemeth, S.; Metrology Division, Hungarian Trade Licensing Office, HUNGARY
|
| Quelle/Jahr | International Journal of Thermophysics: 32 (2011), 11/12, 2708 - 2715 |
| ISSN | 0195-928X (PRINT) ; 1572-9567 (ONLINE) |
| DOI | |
| Verlag | Dordrecht: Springer |
| Konferenzangaben | TEMPMEKO & ISHM 2010, Portoroz, 31 May - 04 June, 2010, Slovenia |
| Freie Schlagworte | Density of heat flow rate ; Round-robin test |
| Zusammenfassung | The first intercomparison on the density of heat flow-rate measurements has been organized by MKEH (Hungarian Trade Licensing Office, Metrology Division) within the framework of EUROMET (Project No. 426). This round-robin test gives evidence about the measurement capabilities of the local realizations of a density of a heat flow-rate scale up to 100 W·m-2. Two types of heat flux plate sensors differing in their size were circulated among partner laboratories. Each one of the six partners calibrated the sensors using its own calibration system, a guarded hot plate or a heat flow meter apparatus. This article compares all the results of the round-robin test and gives the mutual differences among the partners. The participants could benefit from the measurement results by improving, in case of need, their calibration methods and procedures and by reducing their uncertainties. The impact of this comparison will go directly to the users in industry. |
